General
- Weight is sub eight pounds
- All iterations in this series are based on the same UV reactor chamber format, lamp module, electronic controls and mount system.
- Augmented sub-components during assembly allow the same chamber size to become a sediment / particulate filter. ( less Sensor Port )
- Generation 1 required no tools to service; remove the lamp module, quartz or filter cartridge modules, The unnecessary addition of a pin fastener to the UV Module and the Filter Cap. : ( ( poor results)
- The SS Chamber is in use in other potable water products/components
Materials:
- All potable water contact components: 316 SS
- Water Chambers were Spun then Draw Formed
- Water: Machined Hydraulic Function Inserts, Rings, Hydraulic Connect Components
- Sensor window: Sapphire
- Seals: EPDM
- Rings, electrical insulators: PTFE
- Friction/electrical insulation: Kynar / Kapton
- UV REACTOR Sleeve: Quartz
- Extrusions: 6063 AL
- Enclosure Caps, Module Covers, Mounts: 6061 AL
- Pass through Fasteners: SiB
- Fasteners 316/18-8 SS
Horizontal, Top Down Water Flow, Generation 1 (UV+Cartridge Filter)
Horizontal, Top Down Water Flow, Generation 2 (UV+Cartridge Filter)
Vertical, Bottom-Up Water Flow, Single; UV (only)
Vertical, Side entry, Bottom-Up Reactor Water Flow, (UV+Cartridge Filter) Based on Generation 2
- All components are common with Generation 1 and or Generation 2
- Chamber domes both face down
- Chamber to Chamber interconnect with center drain
